Glow RCV 18 - Mopane - Special

Single Piece! With 12mm glass cooling mouthpiece!

TECHNICAL DETAILS:

• Wood type: Mopane (Colophospermum mopane), Africa
• System: On-demand convection (hot air extraction)
• Connection: Standard 510 thread for box mods
• Heating element: Replaceable double coil system (Kanthal A1 Mix Twisted)
• Materials: precious wood, borosilicate glass, stainless steel and silicone
• Power range: 30 - 80 watts (recommended: start at 35W)

GLOW RCV 18 V3 – POWER & FLAVOR FOR YOUR MOD

Pure flavor in seconds. The GLOW RCV 18 V3 is the logical next step in the evolution of our rebuildable convection vaporizers. It transforms your conventional box mod into a high-end convection vaporizer. Thanks to its powerful double-coil heating element, the Glow is ready to use in just about 3 seconds and delivers an unparalleled terpene profile right from the first draw.

Complete Control & Precision: The V3 series sets new standards in handling. With the redesigned airflow ring on the base deck, you can individually adjust the draw resistance. The herb chamber is located directly in the mouthpiece (available in wood or glass), making cleaning and filling a breeze. Whether you prefer a smooth vape or dense clouds, you can easily control the intensity via the wattage setting of your mod.

Durability through modular design : Sustainability meets technology. The heating element is not permanently installed but can be easily replaced or upgraded with your own coils as needed. The high-quality construction using Brazilian peawood and stainless steel ensures that with a little care (using our Woodwax), your Glow will remain a faithful companion for years to come.

SCOPE OF DELIVERY:

• GLOW RCV 18 V3 (base deck, wooden cover and mouthpiece)
• Tool set: screwdriver, tweezers and stir tool (pricker)
• Spare parts set: replacement screws, replacement heating element, O-rings and filters
• Optional: Dreamwood logo engraving available upon request

APPLICATION & PERFORMANCE TIPS:

1. Preparation: Adjust the airflow ring on the base deck and screw the Glow onto the battery carrier.
2. Filling: Pull out the mouthpiece and loosely fill the chamber with herbs. Then insert the mouthpiece back into the cover (Tip: Briefly turn the vaporizer upside down while doing this).
3. Setup: Turn on the battery carrier and set it to approximately 35 watts .
4. To vaporize: Press the power button, preheat for 2-3 seconds, and then inhale evenly for 5-10 seconds.
5. Optimization: If no visible steam is produced, increase the power in 5-watt increments until the desired result is achieved.

Tip: If the wooden cover is too tight, treat the inner edge or the O-rings with a little wood wax . This protects the material and makes assembly easier.

⚠️ IMPORTANT SAFETY INSTRUCTIONS

• Switch off: Always switch off the battery carrier before changing the heating wire or performing any maintenance work!
• Risk of injury: Never touch the heating wire when the device is switched on or has just been fired up.
• Battery safety: Use only high-quality batteries with a minimum discharge current of 20A. Do not use coils with a resistance below 0.10 ohms.
• Personal responsibility: Use is at your own risk. Experience with box mods and electronics is required. Dreamwood Vaporizer accepts no liability for damage caused by improper use.